Venstar Skyport Communications Guide d'installation télécharger pdf (Page 11)

Step 5 - RemoveCurrentBackplate

Unscrewthecurrentbackplateand

removeitfromthewall.Becareful

not to let the wires fall into the wall.

Step 6 - MountNewBase

1) Gentlyseparatethedisplayfromthebasebypullingﬁrstfrom

the bottom and then the top until the two pieces unsnap.

TIP: If needed, wrap the wires

around a pencil or pen to keep

them from falling inside the wall.

REMOVE THE THERMOSTAT BACKPLATE:

UsingtheFingerPullAreas,pullthefront

housing away from the backplate.

W3/AUX

W1/O/B

SENSOR

Backplate

PULL OUT WITH THUMBS IN THESE AREAS.

2) Positionthebaseagainstyour

wall, and determine if wall anchors

from current thermostat align with

screw locations of new base.

3) Ifbasedoesnotalignwithexisting

anchor holes, mark new screw

locations with a pencil.

Drywall:Drill3/16"holefortheanchor

Plaster:Drill7/32”holefortheanchor

4) Pullwiresthroughopeninginbase

and secure to the wall using

provided screws.

TIP:Usealeveltoensure

thermostat is properly aligned

before marking screw locations.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Pas de commentaire

Venstar Skyport Communications Guide d'installation Page 11